-18-
G9959/G9977 Wood Mill
The head casting can be tilted for milling or
drilling at an angle of 90˚ to the left or right. The
belt guard and motor tilt along with the head cast-
ing.
1.
Loosen 3 of the 4 hex nuts shown in
Figure
9.
2.
Loosen the setscrew near the motor
(Figure 10)
with the 4mm Allen
®
wrench
supplied.
3.
While holding the head casting with one
hand, loosen the last hex nut.
4.
Adjust the angle of the head casting until
Head Tilt
Figure 10.
Loosen rear bolt before tilting head.
Figure 9.
Loosen bolts to tilt head.
the pointer is over the desired angle. Snug
up one nut so the head will not shift from
your setting.
More accurate angle set up may be done with a
precision protractor such as the G9900 Dial
Protractor in the current Grizzly catalog. Other
tools such as angle gauges, sine bars and spac-
ers may be employed to set the head casting to
very precise angles.
5.
Once you have determined that the angle
of the head casting is set correctly for your
needs, tighten the rest of the nuts and the
setscrew near the motor.
