-18-
g0667X high precision Vs Vertical Mill
Assembly
To assemble the machine:
1. rotate the head to an upright position (refer
to
Head Movement on Page 26 for detailed
instructions).
2. thread the handles into the ball handles,
then fully tighten them.
Note:
There are two ball handle assem-
blies with a spring-loaded bushing—these
are mounted on either end of the table
leadscrew. The remaining ball handle assem-
bly is installed on the cross feed leadscrew.
3. Align the key on the leadscrew with the key-
way of the ball handle, slide the assembly
onto the leadscrew, then secure it in place
with the hex nut (see
Figure 12).
Figure 12. Ball handle assembly installed on the
leadscrew.
4. remove the five button-head cap screws
shown in
Figure 13 from the saddle and
knee, position the front way cover in place,
then secure it with the cap screws.
Figure 13. Front way cover installed.
Cap screws
5. remove the four button-head cap screws
shown in
Figure 14 from the column and the
rear of the table, position the rear way cover
in place, then secure it with the cap screws.
Figure 14. rear way cover installed.
Cap screws
