-16-
Model T32957 (Mfd. Since 09/21)
7. Insert (2) rear work stop support rods in holes
shown in
Figure 14.
8. Secure rear work stop supprt rods in place
by tightening pre-installed hex bolts (see
Figure 14).
Note:
Rear work stop support rods should
extend same distance from back of machine.
If one rod extends farther than the other,
adjust hex bolts and rods until even.
Figure 14. Rear work stop support rods installed
on machine.
Rear Work Stop
Support Rod
(1 of 2)
Hex Bolt
9. Install (2) rear work stop assemblies on rear
work stop support rods and tighten each
micro-adjustment knob completely to elimi-
nate space shown in
Figure 15.
Figure 15. Rear work stop assembly installed on
rear work stop support rod.
11. Attach rear work stop to rear work stop assem-
blies with (2) M10-1.5 x 20 hex bolts and
10mm flat washers, as shown in
Figure 17.
Micro-Adjustment
Knob (1 of 2)
Rear Work Stop
Assembly
10. Align each work stop indicator to the same
number on rod scales, then tighten micro-
adjustment lock knobs and rear work stop
lock knobs (see
Figure 16).
Figure 16. Rear work stop assembly
components.
Figure 17. Rear work stop attached to rear work
stop assembly.
x 2
Rear Work
Stop Assembly
(1 of 2)
Rear
Work
Stop
Work Stop
Indicator
Micro-Adjustment
Lock Knob
Rear Work Stop
Lock Knob
Eliminate
This Space
Summary of Contents for T32957
Page 36: ......
