Grizzly T32957, Owner'S Manual

Page: 12 / 36

-10-
Model T32957 (Mfd. Since 09/21)
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Loosen Inventory (Figure 4) Qty
A. Front Extension Arms ................................. 2
B. Rear Work Stop Support Rods .................. 2
C. Front Work Stop ......................................... 1
D. Rear Work Stop Assemblies ...................... 2
E. Rear Work Stop .......................................... 1
F. Bevel Gauge ............................................... 1
Figure 4. Loose inventory.
Fasteners (Figure 5) Qty
G. T-Bolts M12-1.75 x 45 ................................. 3
H. Hex Bolts M12-1.75 x 30 ............................. 4
I. Hex Bolts M10-1.5 x 20 .............................. 2
J. Flat Washers 12mm ................................... 7
K. Flat Washers 10mm ................................... 2
L. Wing Nuts M12-1.75 .................................... 3
M. Cotter Pins M3 x 50.................................... 4
N. Clevis Pins 12 x 45mm ............................... 4
O. Clevis Pins 12 x 88mm ............................... 2
Figure 5. Fasteners.
74
72
A
B
C
D
E
F
G H I
J K L
M N O
Note: Some of the clevis pins and cotter pins
listed above have been provided to replace those
pre-installed on the machine in the event they
break due to wear.