Model T28366 (Mfd. Since 04/18)
-17-
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
7. Add coolant to coolant reservoir (refer
to
Checking Coolant on Page 30 for
instructions).
8. Install blade (refer to Installing/Changing
Blades on Page 24 for instructions).
Figure 17. Miter lock lever installed.
6. Thread miter lock lever into miter base
(see
Figure 17).
T28368 —Blade for T28366 Cold Cut Saw
This 160-tooth, 10" (250mm) blade, provides,
straight, burr-free cut and precise miters for a
wide range of metal projects. Features a 1.26"
(32mm) bore.
Figure 18. T28368 blade for T28366 Cold Cut
Saw.
Miter
Lock
Lever
Miter
Base
The Test Run consists of verifying the following:
1) The motor powers up and runs correctly, and 2)
the safety disabling mechanism works correctly.