Grizzly T27961, Owner'S Manual

Page: 10 / 28

Model T27961 (Mfd. Since 02/17) -10
-
Inventory (Figure 1)
A. Table Mounting Pad ...........................1
B. L-Shaped Anchor Bolts ......................2
C. Wing Nuts M8-1.25 ............................2
D. Sander ...............................................1
E. Fender Washer 13mm .......................1
F. Clips ...................................................2
G. Fender Washer 6mm .........................1
H. Rubber Drums
3 ⁄
4
",1", 1 1 ⁄
2
" .......... 1 Ea.
I. Guide Plate ........................................1
J. Dust Port 1
1
⁄
2
".....................................1
K. Cap Screw M6-1 x 12 ........................1
L. Sanding Sleeves
1
⁄
2
",
3
⁄
4
", 1", 1
1
⁄
2
" ............................ 1 Ea.
M. Plastic Knobs M5-.8 x 18 ...................2
N. Hex Wrench 5mm ..............................1
The following is a list of items shipped
with your tool. Before beginning setup, lay
these items out and inventory them.
If any non-proprietary parts are missing
(e.g. a nut or a washer), we will gladly
replace them; or for the sake of expediency,
replacements can be obtained at your
local hardware store.
If you cannot find an item on this
list, carefully check around/inside
the tool and packaging materials.
Often, these items get lost in pack-
aging materials while unpacking or
they are pre-installed at the factory.
Inventory
Figure 1. Inventory.
D
C
B
F
N
I
M
L
H
E
A
J
G
K