-30-
Model T27417 (Mfd. Since 09/15)
7. Remove eight M6-1 x 16 Phillips head screws
(#32) that secure wheel support (#55) to fixed
table (#30), then remove wheel support (#55).
8. Remove four M4 x 22 tap screws (#54) that
secure bearing cover (#77), then remove
cover (see
Figure 37).
11. Remove
3
⁄
8
" drive belt (#88) and upper pulley
(#90) assembly (see
Figure 39) from spindle
(#81), and put Woodruff key (#83) in safe
place for re-assembly.
12. Remove spindle (#81) and lower pulley
assembly (#87)
Note: Ensure the
1
⁄
4
" drive belt (#89) is
clear of tension roller assembly (#52)
during removal.
13. Make sure lower bearing sleeve (#91), shown
in
Figure 40 behind lower pulley (#87) stays
in place.
14. Remove 1⁄4" drive belt (#89) (see Figure 40).
Woodruff
Key
9. Remove upper bearing sleeve (#79) and
compression spring (#80).
10. Remove 17mm external retaining ring (#84)
and spindle washer (#85) from spindle (#81),
as shown in
Figure 38.
Spindle
Washer
External
Retaining
Ring
Spindle
Figure 38. Removing external retaining ring and
washer from spindle.
Figure 39.
3
⁄
8
" drive belt and upper pulley
removed from spindle.
Figure 40. Location of lower bearing sleeve, with
lower pulley and
1
⁄
4
" timing belt removed.
Bearing
Cover
Figure 37. Bearing cover removed.
Spring
Sleeve
3⁄8" Drive
Belt
Upper
Pulley
1
⁄
4
" Drive
Belt
Lower
Bearing
Sleeve
Lower
Pulley
Summary of Contents for T27417
Page 44: ......
