-22-
Model T27417 (Mfd. Since 09/15)
Bevel Sanding
The work table on Model T27417 tilts from 0°–45°
for sanding bevels on your workpiece. The table
tilt stop bracket (see
Figure 25) has detents for
quickly setting the most common angles: 0°, 15°,
22.5°, 30°, and 45°.
Note: You can bevel sand using either the spindle
sander or the edge-sanding attachment.
4. Tilt table to desired angle.
Note: The table will automatically snap into
place at 0°, 15°, 22.5°, 30°, and 45°.
5. Tighten both lock knobs to secure setting.
Setting Work Table Angle
1. DISCONNECT MACHINE FROM POWER!
2. Install spindle sander or edge-sanding
attachment.
3. Loosen both table tilt lock knobs (see
Figure 25).
Figure 25. Location of table tilt components.
Table Tilt
Lock Knob
(1 of 2)
Table Tilt
Stop Bracket
Work Table
To bevel sand, set work table angle, use both
hands to maintain control of workpiece, and slow-
ly guide it against rotation of sanding surface until
desired results are achieved, then turn sander
OFF.
Summary of Contents for T27417
Page 44: ......
