Model T25920/T25926 (Mfd. Since 08/14)
-15-
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
To test run machine:
1. Clear all setup tools away from machine.
2. Connect machine to power supply.
3. Turn machine ON, verify motor operation,
and then turn machine
OFF.
The motor should run smoothly and without
unusual problems or noises.
4. Remove key from toggle switch, as shown
below.
Figure 14. Removing key from toggle switch.
5. Try to start machine.
— Machine should NOT start. If it does start,
switch disabling feature is not functioning
properly and switch must be replaced.
Summary of Contents for T25920
Page 48: ......
