Grizzly T25920, Owner'S Manual

Page: 16 / 48

-14-
Model T25920/T25926 (Mfd. Since 08/14)
Assembly
Assembly consists of installing the electrical box
and tailstock handwheel handle.
Note: If not mounting machine directly to a work-
bench, install the four included rubber feet (see
Figure 12). Adjust feet until lathe sits level, with-
out rocking.
To assemble machine:
1. Mount electrical box to lathe with two pre-
installed Phillips head screws and flat wash-
ers (see
Figure 12).
Figure 12. Rubber feet and electrical box
installed.
Electrical Box
x2
Rubber Feet
(1 of 4)
2. Use flathead screwdriver to install handwheel
handle into tailstock handwheel (see
Figure 13).
Figure 13. Tailstock handwheel handle installed.
Tailstock
Handwheel
Handwheel
Handle
Bench Mounting
Figure 11. "Direct Mount" setup.
Machine Base
Workbench
Lag Screw
Flat Washer
Another option is a "Direct Mount" (see example
below) where the machine is secured directly to
the workbench with lag screws and washers.
The base of this machine has mounting holes
that allow it to be fastened to a workbench or
other mounting surface to prevent it from moving
during operation and causing accidental injury or
damage.
The strongest mounting option is a "Through
Mount" (see example below) where holes are
drilled all the way through the workbench—and
hex bolts, washers, and hex nuts are used to
secure the machine in place.
Machine Base
Workbench
Hex
Bolt
Flat Washer
Flat Washer
Lock Washer
Hex Nut
Figure 10. "Through Mount" setup.
Number of Mounting Holes ............................ 4
Diameter of Mounting Hardware Needed ..
1
⁄
4
"