-6-
t10499/t10500 Blade Welder
the alignment wings keep the blade straight when
cutting with the shear.
Tools Needed
Qty
phillips screwdriver #2 ...................................... 1
Wrench or socket 10mm ................................... 1
To attach the blade shear wings:
1. remove the two phillips head screws shown
in
figure 6, and the attached hex nuts, and
flat washers.
Note: Keep the spacers that separate the two
plates in place.
figure 6. phillips head screws to be removed.
remove these
screws
2. use the fasteners removed in Step 1 to
attach the alignment wings in the positions
shown in
figure 7.
figure 7. Alignment wings installed.
Alignment Wings
Assembly
except for the blade shear alignment wings (see
figure 5), the welder is shipped fully assembled.
figure 5. Blade shear alignment wings.
Extension Cords
We do not recommend using an extension cord
with this machine. If you must use an extension
cord, only use it if absolutely necessary and only
on a temporary basis.
Extension cords cause voltage drop, which may
damage electrical components and shorten motor
life. Voltage drop increases as the extension cord
size gets longer and the gauge size gets smaller
(higher gauge numbers indicate smaller sizes).
Any extension cord used with this machine must
contain a ground wire, match the required plug
and receptacle, and meet the following require-
ments:
T10499 Minimum gauge Size ..............14 AWg
T10500 Minimum gauge Size ..............12 AWg
Maximum Length (Shorter is Better).......25 ft.