5.9. Inserting the selector plate
After
correct installation of new processor unit reinsert the selector plate to its original position. Check if magnet is
directly over the hall probe when selector plate is in position „auto“. Everything was tested on more guns but may
happen that that the ARES manufacturer changes gearbox or dimensions of plate without notice. This situation will
be necessary to deal with the GRIZZLY manufacturer.
Pict. 9: Checking the settings of selector plate’s magnet with the probe hall
5.10.1 Magnet installation on the trigger
Set the trigger to position, where you want your replica to fire. Put the magnet on trigger as close as possible to
the sensor. If you want sensitive trigger put the magnet as closest to the probe when your trigger isn’t pressed
(just before the LEDs light up). LED has never lights
in the basic position.
Now stick the magnet. Magnet’s polarity doesn’t matter.
If needed, you can very gently bend the probe to be very close to magnet when you press trigger, but not to
touch it.
Pict.10: Installation magnet onto the trigger
Summary of Contents for PSJ-VZ58 gen3 OEM
Page 1: ......
