3.2. Rate of fire
•
allows you to set delay between the two following shots
•
allows smooth rate of fire setting
•
programmable by trigger (see figure 6.2.)
3.3. Special functions
•
default settings reset: You can simply reset all settings to their default values by trigger (see figure 6.2.)
•
manual mode: If your PSJ indicates damage and you are sure it is not mechanical and your replica is able to
shoot, you can access manual mode in which malfunction is ignored. You can then fire on full auto mode
only (see figure 6.4).
•
WARNING! By poor judgement, you can cause more damage to your replica and the unit!
3.4. MOS-FET
•
no mechanical switch, switching is contactless
•
faster trigger response
•
increased rate of fire and battery life
•
maximum current up to 202A constant and 808A in peek
3.5. Active brake
•
stops motor immediately with piston in default position and spring loose (when 100% set)
•
increases lifetime of piston, spring and many other parts
•
always finishes whole rotation of gear wheels
•
fully functional in all fire modes
•
adjustable by steps of 10%
•
possibility to completely disable active brake (set 0%)
3.6. Malfunction detection
•
unit detects mechanical damage and disables shooting to prevent any other damage
•
user is warned by motor vibrations (see figure 6.3.)
3.7. Li-Pol/Li-Ion/Li-Fe battery check
•
when lithium battery is discharged, unit warns user by motor vibrations (see figure 6.3.)
•
battery type needs to be set – easily done using trigger itself (see figure 6.2.)
•
warning is off for Ni-MH, Ni-Cd batteries
3.8. Realistic trigger operation
•
trigger sensitivity can be set during installation to best fit your demands
3.9. Anti-reversal latch
•
solves problem with double shot on semi
•
anti-reversal latch may not be needed if the motor is powerful enough (not recommended)
3.10. All this hidden inside your gearbox
•
the whole unit is installed inside your gearbox, replacing trigger contacts
•
only two power wires come from gearbox
•
unit is equipped with LED indication of correct installation for easier installation
4. Technical parameters
•
Top quality silicone wiring. 1mm
2
in cut capable of transmitting up to 47A constant.
•
Powerful MOSFET with maximum current up to 202A constant and 808A in peak allows use almost without
any restrictions.
•
MOSFET is effectively cooled by the whole gearbox.
•
The whole unit is coated in multiple layers of varnish for maximum durability even in poor conditions.
•
Replica‘s rate of fire is limited by gearbox components and technical specifications. PSJ unit itself is able to
do up to 500 000 cycles (shots) per second. Unit is tested for 99 cycles (shots) per second.
•
Current consumption of unit in standby mode is as low as 3.9mA.
Summary of Contents for PSJ-VZ58 gen3 OEM
Page 1: ......
