-12-
Model G4000 (Mfg. Since 8/09)
inventory
inventory: (figures 3–4)
Qty
A. Faceplate 7
1
⁄
2
" ............................................ 1
B. 4-Jaw Chuck 7
1
⁄
4
" ....................................... 1
C. 3-Jaw Chuck 4" .......................................... 1
D. reverse Jaws for 3-Jaw Chuck ............1 set
E. C-type tool holder ..................................... 1
f. dead Center Mt#2 ..................................... 1
G. dead Center Mt#3 ..................................... 1
H. Live Center Mt#2 ....................................... 1
i. Change gears:
— 30t gears ............................................... 2
— 36t gear ................................................. 1
— 42t gear ................................................. 1
— 45t gear ................................................. 1
— 80t gears ............................................... 2
J. tool Box...................................................... 1
K. standard & phillips screwdrivers ......1 Each
L. Combo Wrenches 8/10, 12/14mm .....1 Each
M. hex Wrenches 1.5, 2, 4, 5, 6mm .......1 Each
N. oil Bottle ..................................................... 1
O. Belt tension Lever Knob ............................ 1
p. Chuck Bars ................................................. 2
Q. 3-Jaw Chuck Key ....................................... 1
R. 4-Jaw Chuck Key ....................................... 1
S. hardware (not shown):
— hex Bolts M10-1.5 x 30 ........................... 2
— hex Bolt M8-1.25 x 30 (C-type holder) .. 1
— hex nuts M8-1.25 (C-type holder) ......... 1
— pin 8 x 20mm (C-type holder) ............... 1
— phillips head screws M8-1.25 x 16 ........ 4
— hex nuts M8-1.25 ................................... 3
— high hex nut M8-1.25 ............................ 1
— Flat Washers 8mm .................................. 9
—Compression spring 10 x 40mm ............ 1
figure 3. Model g4000 inventory 1.
A
B
C
d
E
g
F
h
i
figure 4. Model g4000 inventory 2.
J
K
L
n
M
o
p
Q
r
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.