-18-
G1037Z 13" Planer/Moulder
Figure 15.
Installing handwheel.
Components and Hardware Needed:
Qty
Handwheel ........................................................1
Handwheel Handle ............................................1
Tools Needed:
Screwdriver ........................................................1
The handwheel is used to raise and lower the
planer/moulder work table.
To install the handwheel:
1.
Place the handwheel over the shaft shown in
Figure 15.
Rotate the handwheel until the
pin in the shaft slides into the groove in the
handwheel.
Pin
Figure 14.
Dust hood installed.
Components and Hardware Needed:
Qty
Dust Hood ..........................................................1
Cap Screw M5-.8 x 8 ........................................3
Flat Washer 5mm ..............................................3
Cap Screw M6-1.0 x 12 ....................................1
Flat Washer 6mm ..............................................1
Tools Needed:
Hex Wrench 4mm ..............................................1
Hex Wrench 5mm ..............................................1
It is important to connect the planer /moulder to a
dust collection system to reduce the health risks
associated with airborne wood dust.
To install the dust hood:
1.
Slide the dust hood under the chip guard
bracket and bolt together using the M5-.8 x 8
cap screws and 5mm flat washers. See
Figure 14
.
2.
Use the M6-1.0 x 12 cap screw and 6mm flat
washer to secure the bottom edge of the dust
hood.
3.
Attach a 4" dust collection hose to the dust
hood with a hose clamp.
2.
Place the handle shaft through the handle
and screw it into the handwheel with the
screwdriver.
Handwheel
Dust Hood
