G1037Z 13" Planer/Moulder
-23-
Figure 18.
Fence rod brackets
Components and Hardware Needed:
Qty
Moulding Fence..................................................2
Moulding Fence Guide Rod ..............................1
Bracket ..............................................................2
Locking Knob (Male) M6-1 x 20 ........................2
Cap Screw M6-1 x 20 ........................................6
Cap Screw M6-1 x 10 ........................................4
Flat Washer 6mm ..............................................6
Lock Washer 6mm ............................................6
Clamping Block ..................................................2
Tools Needed:
Hex Wrench 5mm ..............................................1
The moulding fences align the workpiece with the
moulding knives.
To install the moulding fences:
1.
Disconnect the machine from the power
source!
2.
Bolt the moulding fences to the clamping
blocks with the M6-1 x 10 cap screws and
lock washers.
3.
Screw the locking knobs into the clamping
blocks.
5.
Slide the fence rod between the brackets and
thread the remaining cap screws, with flat
washers and the lock washers, into the ends.
6.
Place the moulding fences over the fence rod
and tighten the locking knob.
7.
Adjust the fence rod brackets until the fences
lie flat on the surface of the bedboard or work
table and tighten the cap screws.
Moulding Fence
Clamping Block
Fence Guide Rod
Fence Guide Rod Bracket
Moulding Fences
4.
Install the fence rod guide brackets onto the
edge of the work table with 4 cap screws and
flat washers as shown in
Figure 18
. Do not
tighten the cap screws at this time.
