Grizzly G1023S, Instruction Manual, Page: 27 / 52

G1023S/G1023S110 Heavy-Duty 10'' Table Saw -25-
Blade Alignment
The blade position can be adjusted slightly in
case it contacts the table insert when raised or
tilted. This adjustment can be made either by
moving the whole trunnion assembly, or by just
moving the arbor bracket. Try adjusting by mov-
ing the whole trunnion first, this is the easier of
the two ways.
To adjust the blade position by moving the trun-
nion:
1. Disconnect plug from power source.
2. Remove the table and wings and set them to
one side. Be sure to note the position of the
table shims. Replace them to their original
position before re-attaching the table.
3. Loosen the four trunnion mounting bolts as
shown in Figure 27, and nudge to either the
left or right depending on where the blade is
hitting the saw.
The table and wings rep-
resent a very heavy load.
DO NOT over-exert your-
self while lifting or mov-
ing the table and wings
– get assistance.
Figure 27. Trunnion mounting bolts.
To adjust the blade position by moving the arbor
bracket:
1. Disconnect plug from power source.
2. Remove the table and wings and set them to
one side. Be sure to note the position of the
table shims. Replace them to their original
position before re-attaching the table.
3. Loosen the bracket lock bolt shown in
Figure 28.
4. Slowly slide the arbor bracket towards the
end of the shaft.
4. Re-attach the table, making sure there is
adequate blade clearance through all blade
adjustments. Recheck guard alignment to
the blade and to the table top. Adjust as nec-
essary and tighten down all the bolts before
use.
5. If the blade is still contacting the insert,
repeat
Steps 1-4. Check all other adjust-
ments .
6. Recheck the blade to miter slot adjustments,
and adjust as necessary.
Figure 28. Adjusting arbor bracket.
NOTICE
If you make the adjustment described in this
section, check and adjust the blade splitter
to make sure it aligns with the blade.
Bracket Lock Bolt
Trunnion Mount Bolts
Arbor Bracket