-20-
Model G1023RL Series (Mfd. Since 12/11)
8. Model G1023RL: Continue repeating Steps
3–7 in a similar manner to install the right
extension wing.
Model G1023RLW or G1023RLWX: Do not
mount the router table extension wing yet.
Mount it to the right side of the table after the
fence rails and rail tube are installed. Refer to
Router Table & Legs on Page 22.
Model G1023RLX: Do not mount the exten-
sion table yet. Mount it to the right side of the
table after the fence rails and rail tube are
installed. Refer to
Extension Table & Legs
on
Page 22.
9. Remove the ON/OFF switch from the cabinet
and remove the cardboard box used to pro-
tect it during shipping.
7. Place the straightedge across the extension
wing and main table to make sure that the
combined table surface is flat.
— If the combined table surface is flat, skip to
the next step.
— If the outside end of the extension wing
tilts down, use a strip of masking tape
along the bottom edge of the main table
to shim the extension wing up (see
Figure
14).
— If the outside end of the extension wing
tilts up, use a strip of masking tape along
the top edge of the main table to shim the
extension wing down (see
Figure 15).
Figure 15. Masking tape location for adjusting
the extension wing down.
Note: After reinstalling wings, remove all
excess masking tape with a razor blade.
Figure 14. Masking tape location for tilting the
extension table up.
Figure 16. Installing switch.
10. Attach the switch to the extension wing with
(1)
5
⁄
16
"-18 x
3
⁄
4
" flat head screw in front, as
shown in
Figure 16, and (1)
5
⁄
16
" flat washer
and (1)
5
⁄
16
" hex nut in back.
x 1
