-42-
Model G0954/55/56/57 (Mfd. Since 11/21)
Figure 56. Location of motor pulley set screws.
6. Adjust position of motor pulley on shaft until
distances from
Step 4 (see Figure 55) are
within
1
⁄
16
" of each other, then tighten set
screws.
7. Install belt guard.
5. Loosen (2) motor pulley set screws (see
Figure 56).
3. Place straightedge so it is flush against pump
flywheel and it extends over motor pulley
(see
Figure 54).
4. Measure distance between straightedge and
V-belt at "A", "B", and "C" locations shown in
Figure 55.
— If measurements are all within
1
⁄
16
" of each
other, pulley and flywheel are coplanar
and do not need to be adjusted. Proceed
to
Step 7.
— If measurements are not all within
1
⁄
16
" of
each other, pulley and flywheel are not
coplanar. Proceed to
Step 5.
A
B
C
Motor
Pulley
Pump
Flywheel
Figure 55. Distances to measure.
Figure 54. Example of using straightedge to
check pulley alignment.
Pump Flywheel
Straightedge
Motor
Pulley
Summary of Contents for G0954
Page 64: ......
