Grizzly G0926, Owner'S Manual

Page: 21 / 56

Model G0926 (Mfd. Since 11/20)
-19-
Figure 17. Work stop secured on rod.
12. Slide work stop onto rod and secure with pre-
installed wing nut (see Figure 17).
13. Attach chip tray to base with M8-1.25 x 16
knob bolt (see
Figure 18).
Figure 18. Dust box installed on base.
To test run machine:
1. Clear all setup tools away from machine.
2. Connect machine to power supply.
3. Remove head-locking pin and raise head-
stock.
4. Turn machine ON, verify motor operation,
and then turn machine OFF.
Motor should run smoothly and without
unusual problems or noises.
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
The Test Run consists of verifying the following:
1) The motor powers up and runs correctly, 2) the
switch disabling key disables the switch properly,
3) the auto-off tab shuts down power, and 4) the
variable-speed dial works correctly.
Work Stop Rod
Knob Bolt
Dust Box
Work Stop