Model G0895 (Mfd. Since 01/20)
-21-
Lifting & Placing
Do not attempt to lift or move this machine without
using the proper lifting equipment (such as forklift
or hoist) or the necessary assistance from other
people. Each piece of lifting equipment must be
rated for at least 2500 lbs. to support dynamic
loads that may be applied while lifting. Refer to
Needed for Setup on Page 17 for complete list
of needed equipment for setup and installation.
Tools Needed
Qty
Forklift or hoist (rated for 2500 lbs.) .................. 1
To lift and move machine:
1.
Move crate to machine work site.
2. Remove crate top and sides, small items
inside crate, and blocks around machine
base.
3. Lift machine by lift beams on underside of
machine body (see
Figure 16) with forklift or
hoist. Only lift machine enough to clear pallet,
then move pallet out of the way.
5. Connect 2" vacuum hose to vacuum valve
inlet with 2" hose clamp. Then route hose out
from under rear of machine (see
Figure 18).
HEAVY LIFT!
Straining or crushing injury
may occur from improperly
lifting machine or some of
its parts. To reduce this
risk, use a forklift (or other
lifting equipment) rated for
weight of this machine.
Figure 17. Leveling foot.
4. Install (6) leveling feet (see Figure 17) on
bottom of machine.
Figure 16. Lift beams located under machine
body.
Lift Beam
6. Lower machine to ground.
2" Vacuum Hose
Vacuum
Valve Inlet
2" Hose Clamp
Figure 18. Hose connection at rear of machine
shown from underneath table.
Summary of Contents for G0895
Page 60: ......
