Model G0893 (Mfd. Since 03/19)
-25-
4. Use a machinist's combination square to
check fence angle, as shown in
Figure 30.
Figure 30. Checking 45º outward (135º) stop.
Machinist's
Square
— If fence tilts away from table at 135º, out-
ward stop is set correctly. Put limit block
back, bring fence to 90° and tighten fence
tilt lock.
— If fence is not tilting away from table at
135º, do
Steps 5–6 to set outward stop
correctly.
5. With outward stop bolt resting against fence
bracket, adjust length of stop bolt until fence
is at 45º, then tighten jam nut (see
Figure 31).
3. Loosen fence tilt lock, and release fence from
90° limit block stop.
4. Tip fence towards table as far as it will go,
ensuring limit plate stays in limit block rear
slot, then tighten fence tilt lock.
Note: When fence tilts towards table, it
will stop when it contacts inward stop (see
Figure 27).
5. Remove limit block from fence bracket
assembly and set it aside (see
Figure 29).
6. Adjust inward stop bolt (see Figure 29)
until it contacts fence face at precisely 45º
inward, then tighten jam nut (where bolt
meets bracket assembly) while holding stop
bolt in place. Replace limit block and set limit
plate.
Figure 29. Adjusting the inward stop.
Limit
Plate
Limit
Block
Inward
Stop
Bolt
Setting 135° Fence Stop
1. DISCONNECT MACHINE FROM POWER!
2. Loosen fence tilt lock, remove limit block and
set it aside.
Note: You may need to move fence carriage
toward front of machine slightly to avoid bot-
tom of fence catching on edge of table.
3. Tip fence back (away from table) until it
stops.
Note: Fence will stop when outward stop bolt
contacts fence bracket.
6. Put limit block back, position fence at 90º,
and tighten fence tilt lock.
Check accuracy of each setting frequently
with a machinist's combination square and
re-adjust as necessary.
Figure 31. 135º fence stop detail.
135º
Stop Bolt
Jam Nut
Summary of Contents for G0893
Page 53: ......
