COPYRIGHT © MARCH, 2021 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#CS21759 PRINTED IN TAIWAN
The following changes were made since the owner's manual was printed:
•
The round bearing blocks changed to rectangular, which allow cutterhead to outfeed table alignment.
•
A cap screw on the fence changed from 20mm to 16mm long.
•
The fence pivot assembly now comes installed on the carriage and the screws have captive washers.
•
Only one T-25 T-handle torx wrench now ships with the machine instead of two.
•
An
Assembly step has been corrected.
Aside from this information, all other content in the owner's manual applies and MUST be read and under-
stood for your own safety.
IMPORTANT: Keep this update with the owner's manual for future reference.
For questions or help, contact our Tech Support at (570) 546-9663 or [email protected].
READ THIS FIRST
For questions or help with this product contact Tech Support at (570) 546-9663 or [email protected]
Model G0893
***IMPORTANT UPDATE***
For Machines Mfd. Since 02/21
and Owner's Manual Revised 06/20
Revised Parts Breakdown
39V2
57
77V2
117
101
1V2
35V2
REF PART #
DESCRIPTION
1V2
P0893001V2 OUTFEED TABLE V2.02.21
35V2 P0893035V2 CAP SCREW M8-1.25 X 16 V2.02.21
39V2 P0893039V2 CAP SCREW M6-1 X 12 V2.02.21
57
P0893057
LOCK WASHER 6MM
77V2 P0893077V2 BEARING BLOCK (FRONT) V2.02.21
101
P0893101
SET SCREW M8-1.25 X 8
117
P0893117
BEARING BLOCK (REAR)
9. Use (2) M8-1.25 x 30 cap screws, (2) 8mm
lock washers, and (2) 8mm flat washers to
attach each handle to each end of the jointer
tables (see
Figure 17).
Figure 17. Handle attached to end of table.
x 2
Table
Handle
Jointer
Table
Corrected Assembly Step
Summary of Contents for G0893
Page 53: ......
