Grizzly G0841, Owner'S Manual, Page: 9 / 84

Model G0841 (Mfd. Since 06/18)
-7-
M. Digital Display: Displays current final
workpiece thickness (i.e., distance from BDC
of upper cutterhead to planer table).
N. Unit/Mode Display: Identifies active unit
of measurement (INCH or MM) and mode
(INPUT or RUN) of digital contol pad.
O. SET Key:
Press
SET
key to enter Input mode.
INPUT is highlighted in the unit/mode display
(see
Figure 2). Input mode must be active to
enter a final workpiece thickness value.
P. UNIT Key: Press
UNIT
key to switch between
inches or millimeters as unit of measure-
ment for digital control pad. The selected
unit (INCH or MM) is highlighted in unit/mode
display (see
Figure 2).
Q. Plus & Minus Keys: Press + or − keys
to quickly raise or lower the headstock,
which increases or decreases final workpiece
thickness (i.e., distance from BDC of upper
cutterhead to planer table). Push and hold
buttons to raise or lower headstock steadily,
or push and release buttons to raise or lower
headstock in 0.01" or 0.1mm increments.
R. Start Key: Press
key to enter Run
mode. The headstock will move up or down,
depending on the entered final workpiece
thickness (i.e., distance from BDC of upper
cutterhead to planer table).
S. Stop Key: Press
i
key while in Run mode
to immediately stop headstock while it is
moving
.
T. Clear Key:
Press
C
key to clear current
final workpiece thickness value while in Input
mode.
U. Numerical Key Pad:
Enter specific values
for final workpiece thickness. Press 0–9 and
decimal keys as needed to enter desired final
workpiece thickness. The displayed value
flashes until you press
key.
Example: To enter a final workpiece thick-
ness of 2
1
⁄
2
", press
SET
key, then press follow-
ing keys:
2 •
5 0
, and then press key.
Headstock (Front)
Figure 3. Headstock (front) controls &
components.
V. Variable Frequency Drive (VFD) Control
Module: Set at factory. DO NOT adjust!
W. Feed Rate Dial: Turn to set machine feed
rate between 0–100% (26–72 FPM). Feed
rate is the speed in Feet Per Minute (FPM)
that the feed system moves workpieces
through the machine.
X. Feed Track Pressure Adjustment w/Scale
& Lock Lever: Adjust to increase or decrease
feed track pressure on workpiece. Set pres-
sure to "0" for normal planing operations; if
belt slips on workpiece, increase downward
pressure by no more than 0.5mm at a time.
Y. Feed Track Tensioner (1 of 2): Tighten or
loosen spring-loaded hex bolt to increase or
decrease tension on the feed track.
Z. Infeed Safety Guard w/Emergency Stop
Plate: Provides additional safety for operator
when feeding workpieces into machine. Guard
is adjustable for varying pre-cut workpiece
thicknesses. If contact is made with emer-
gency stop plate, cutterhead motors and feed
system immediately stop.
AA. Feed Track: Feeds workpieces into lower
cutterhead and toward serrated roller (refer
to
Feed Track on Page 10 for more informa-
tion).
V
W X
Y
Z
AA