Grizzly G0841, Owner'S Manual, Page: 8 / 84

-6-
Model G0841 (Mfd. Since 06/18)
Controls &
Components
Refer to
Figures 1–7 and the following descrip-
tions to become familiar with the basic controls
and components of this machine. Understanding
these items and how they work will help you
understand the rest of the manual and how to
properly operate this machine.
To reduce your risk of
serious injury, read this
entire manual BEFORE
using machine.
A. Power Button: Push to enable power to all
motors and electrical systems (if Emergency
Stop buttons are not in depressed position).
B. Power Lamp: Illuminates when machine is
connected to power.
C. Lower Cutterhead Motor Amp Meter:
Displays lower cutterhead motor amp draw.
D. Upper Cutterhead Motor Amp Meter:
Displays upper cutterhead motor amp draw.
E. Automatic Oiler On/Off Switch: Use to turn
automatic oiler system on and off. Always
turn
ON before starting feed system.
Control Panel
F. Upper Cutterhead Off Button: Push to stop
upper cutterhead motor. (Upper cutterhead
requires 30–40 seconds to come to complete
stop.)
G. Upper Cutterhead On Button: Push to start
upper cutterhead motor. (Upper cutterhead
requires 5–15 seconds to reach full speed.)
H. Lower Cutterhead Off Button: Push to stop
lower cutterhead motor. (Upper cutterhead
requires 30–40 seconds to come to complete
stop.)
I. Lower Cutterhead On Button: Push to start
lower cutterhead motor. (Lower cutterhead
requires 5–15 seconds to reach full speed.)
J. Feed System Off Button: Push to stop feed
system.
K. Feed System On Button: Push to start feed
system, including: feed track, serrated roller,
pressure rollers, and chain drive. Button only
functions when cutterheads reach full speed.
L. Emergency Stop Button (1 of 2): Push to
stop all machine functions and disable power
button. Remains in depressed position until
manually reset. Reset by twisting button
clockwise until it springs outward.
Digital Control Pad
Figure 1. Control panel.
B
A
L K
F
C D E
G H
I
J
Note: You use the digital control pad to enter a
value for your final workpiece thickness (i.e., dis-
tance from bottom dead center (BDC) of upper
cutterhead to planer table).
Figure 2. Digital control pad.
N
S
O
U
R
Q
P
M
T