Model G0806/G0807 (Mfd. Since 12/15)
-53-
Replacing Blade
Guides & Supports
With use, the faces of the blade guides will wear
at an angle and it may become difficult to prop-
erly adjust them. If this is the case, swap and turn
blade guides over so that they are reversed rela-
tive to the blade (see
Figure 69).
When the blade guides are no longer effective
after reversing them, then replace them with new
guides (Grizzly Part Number P0806247).
Swap &
Turn Over
Rotate
Blade Support
Wear
Mark
Figure 69. Blade guide and support orientation.
As the blade is deflected back into the blade
support during operation, a groove will eventu-
ally wear into the blade support. As this groove
becomes deeper, it can affect the accuracy of the
cut. When this happens, loosen the blade support
cap screw and rotate the blade support 90°, as
shown in
Figure 69.
If necessary, the end of the blade support can be
ground flat to extend its life. When it becomes too
short to properly support the blade, replace it with
a new one (Grizzly Part Number P0806249).
Note: Make sure to readjust the blade guides and
support as directed in
Adjusting Blade Guide
Assemblies on Page 25 after making these
changes.
Summary of Contents for G0806
Page 80: ......