-24-
Model G0795Z (Mfd. Since 06/17)
Tools Needed
Qty
Wrench 16mm ................................................... 1
Spindle Wrench.................................................. .... 1
To install tooling:
1. DISCONNECT MACHINE FROM POWER!
Removing Tooling
Tools Needed
Qty
Wrench 16mm ................................................... 1
Spindle Wrench ................................................. 1
Brass-Head or Dead-Blow Hammer .................. 1
To remove tooling:
1. DISCONNECT MACHINE FROM POWER!
2. Unlatch and open motor cover to expose
drawbar.
3. Place spindle wrench over spindle flats to
keep the spindle from rotating, and use
16mm wrench to loosen drawbar one full
rotation.
Note: Do not fully unthread tooling from
drawbar or the drawbar and tool threads
could be damaged in the next step.
4. Tap top of drawbar with brass-head or dead-
blow hammer to unseat taper.
5. Hold onto tooling with one hand and fully
unthread drawbar with other hand.
6. Place 16mm wrench over drawbar, then
use spindle wrench on spindle flats (see
Figure 23) to keep spindle from rotating.
Do not overtighten drawbar. Overtightening
makes tool removal difficult and may dam-
age arbor and threads.
7. Tighten drawbar and close motor cover.
2. Unlatch and open motor cover on headstock
to expose drawbar (see
Figure 22).
Figure 23. Location of spindle flats and drawbar.
Drawbar
Spindle
Flats
Cutting tools are sharp and
can easily cause laceration
injuries. Always protect
your hands with leather
gloves or shop rags when
handling cutting tools.
3. Install drawbar (see Figure 4 on Page 12).
4. Position tool slot (see Page 23) with pin
inside spindle, then insert tooling into spindle
until it contacts drawbar.
5. Working from top end, thread drawbar by
hand into tooling until snug.
Figure 22. Drawbar location under motor cover.
Drawbar
Motor
Cover
Motor
Installing Tooling
Summary of Contents for G0795Z
Page 64: ......
