Grizzly G0795Z, Owner'S Manual

Page: 24 / 64

-22-
Model G0795Z (Mfd. Since 06/17)
1. DISCONNECT MACHINE FROM POWER!
2. Loosen the (3) hex nuts (see Figures 16–17)
that lock headstock tilt in position.
3. Using tilt scale shown in Figure 16 as a
guide, push or pull headstock to swivel it into
desired position, then retighten the (3) hex
nuts to secure it.
Figure 16. Headstock hex nut (one on each side
of headstock).
Tilt
Scale
Hex Nut
(1 of 3)
Figure 17. Hex nut underneath headstock
(headstock tilted 90° for clarity).
Hex Nut
(1 of 3)
Adjusting Headstock
4. Tighten lock levers to secure setting.
The headstock can be adjusted up and down the
column (Z-axis) and tilted 45° left or right rela-
tive to the table. A scale is provided to indicate
the tilting angle of the headstock. However, this
should be used as a general guide–not relied on
for precision operations. Refer to the section on
"Tramming the Headstock" for additional details
on precisely positioning the head at 0°.
Adjusting Headstock Height
1. DISCONNECT MACHINE FROM POWER!
2. Loosen both lock levers shown in Figure 15.
3. Use headstock elevation crank shown in
Figure 15 to adjust headstock height.
Figure 15. Location of headstock elevation
controls.
Headstock
Elevation
Crank
Lock
Levers
Tilting Headstock