-32-
Model G0762 (Mfd. Since 5/14)
Headstock
Lube Type .. Model SB1365 or ISO 68 Equivalent
Lube Amount .............................................3
1
⁄
4
qt.
Check/Add Frequency ........... 8 hrs. of Operation
Change Frequency ................................ Annually
The headstock has the proper amount of oil when
the sight glass shown in
Figure 38 is halfway full.
Tool Needed
Qty
Hex Wrench 8mm .............................................. 1
To change headstock oil:
1. Run spindle at 670 RPM for approximately 10
minutes to warm oil.
2. DISCONNECT MACHINE FROM POWER!
3. Remove fill plug (see Figure 38).
4. Place a 1-gallon or larger drain pan on table
under headstock.
5. Remove drain plug (see Figure 39) from
underneath headstock and allow oil to drain
into pan.
Follow federal, state, and local require-
ments for proper disposal of used oil.
6. Replace drain plug.
7. Add oil until sight glass is halfway full, then
replace fill plug.
8. Clean up any spilled oil to prevent slipping
hazards.
Figure 39. Headstock drain plug
(headstock tilted 90° for clarity).
Drain
Plug
Figure 38. Headstock oil fill plug and sight glass.
Sight
Glass
Fill
Plug
Summary of Contents for G0762
Page 45: ...Model G0762 Mfd Since 5 14 43 Figure 51 Electrical cabinet...
Page 60: ......
