Grizzly G0761, Owner'S Manual, Page: 27 / 56

Model G0761 (Mfd. Since 10/13)
-25-
Installing Tooling
Tools Needed Qty
Wrench 19mm ................................................... 1
To install tooling:
1. disConneCt MAChine FroM poWer!
2. remove drawbar cap, as shown in Figure 24.
3. position tool alignment slot (see Figure 23
on previous page) with pin inside spindle,
then insert tooling into spindle until it contacts
drawbar.
Note: Height of drawbar inside spindle can
be changed by rotating adjustment nut (see
Figure 24).
4. Working from the top, thread drawbar by
hand into tooling until it is snug, then use
wrench to tighten it.
Note: Do not overtighten drawbar.
Overtightening makes tool removal difficult
and will damage arbor and threads.
5. re-install drawbar cap.
Removing Tooling
Tools Needed Qty
Wrench 19mm ................................................... 1
Brass head or dead Blow hammer .................. 1
To remove tooling:
1. disConneCt MAChine FroM poWer!
2. remove drawbar cap.
3. unthread drawbar from tooling one full rota-
tion.
Note: Do not fully unthread tooling from
drawbar, or the drawbar and tool threads
could be damaged in the next step.
4. tap top of drawbar with hammer to unseat
taper.
5. hold onto tooling with one hand and fully
unthread drawbar.
Figure 24. drawbar components.
Adjustment
nut
drawbar
drawbar
Cap