-24-
Model G0761 (Mfd. Since 10/13)
A. ON/OFF Light. illuminates when the unit is
turned
ON.
B. Direction Lever. Controls the direction of
powered table travel.
C. Rapid Switch. Moves the table rapidly in the
direction chosen when held down.
D. Power Light. illuminates when the unit is
connected to power.
E. Speed Dial. Controls the rate of power feed.
F. ON/OFF Switch. turns the power feed ON
and
OFF.
Figure 22. limit switch and limit stops.
g
h
Installing/Removing
Tooling
the Model g0761 includes the following spindle
tools (see
Figure 23):
A. B16 Drill Chuck w/R-8 Arbor. Joined with
the drill chuck.
B. R-8–MT#3 Spindle Sleeve. used for Mt#3
tools and will accommodate tools with a tang.
it also has a drift key slot for tool removal.
C. MT#3–MT#2 Spindle Sleeve. used with the
r-8–Mt#3 spindle sleeve for Mt#2 tools and
has a drift key slot for tool removal.
Cutting tools are sharp and
can easily cause laceration
injuries. Always protect
your hands with leather
gloves or shop rags when
handling cutting tools.
Figure 23. tool and arbors included with
Model g0761.
A
B
C
drift Key slot
Alignment slot
X-Axis Power Feed
use
Figures 21–22 and the following descriptions
to become familiar with the power feed controls.
Note: The power feed must be connected to an
independent, grounded 110V power supply to
operate.
G. Limit Stops. Work with limit switch to restrict
X-axis table movement.
H. Limit Switch. stops table movement when
either side plunger contacts a limit stop.
Figure 21. X-axis power feed controls.
A
B
F
e
d
C
Summary of Contents for G0761
Page 56: ......