Grizzly G0761, Owner'S Manual, Page: 18 / 56

-16-
Model G0761 (Mfd. Since 10/13)
Assembly
the mill/drill was fully assembled at the factory
except for the handwheel handles.
use a flat-head screwdriver to attach the
handwheels handles, as shown in
Figure 9.
Figure 9. handwheel handles attached.
handwheel handles
An arbor is included for the drill chuck that
comes with this machine. the following procedure
describes how to install the arbor in the chuck.
After the arbor is installed in the drill chuck, it
is very difficult to separate the assembly. if you
would like to use a different chuck in the future,
we recommend obtaining a new arbor.
Important: do not install the drill chuck and
arbor into the spindle until AFter the test run.
To join the drill chuck and arbor:
1. use mineral spirits to clean drill chuck and
arbor mating surfaces, especially the bore.
2. retract chuck jaws completely into chuck.
3. insert small end of arbor into chuck.
4. hold assembly by arbor and tap chuck onto
a block of wood with medium force, as illus-
trated in
Figure 10.
Joining Drill Chuck
& Arbor
Figure 10. tapping drill chuck/arbor on block of
wood.
5. try to separate drill chuck and arbor by hand .
if you can pull them apart, repeat this proce-
dure.