Model G0718 (Mfd. Since 12/10)
-27-
2. Place a hinge against the edge of the scrap
board and mark the hinge cup depth on the
side of the board, as shown in
Figure 38.
Note: If the hinge requires the pilot holes to
be deeper or shallower than the cup hole,
adjust the individual bit depths as necessary
at this time (refer to
Installing Boring Bits
on
Page 25).
3. Place the scrap board flush against the table
and the fence.
4. Lower the boring head, then turn the depth
adjustment knob as needed until the cup bit
or a pilot bit is aligned with the mark on the
scrap board (see
Figure 39), then remove
the scrap board.
Figure 39. Bit aligned with depth mark.
Bits Aligned
with Mark
Figure 38. Hinge cup bottom depth marked on
scrap board.
Hinge Cup
Depth
1. DISCONNECT BORING MACHINE FROM
POWER!
Items Needed
Qty
Scrap Board (Same Thickness as Workpiece
and at least 12" long) ......................................... 1
Ruler .................................................................. 1
Hex Wrench 3mm .............................................. 1
Wrench 10mm ................................................... 1
Drilling Depth
Setback Distance
1. Determine the amount of setback required
(see
Figure 37), then mark it on the scrap
board.
Note: Refer to the hinge manufacturer's
instructions for the setback distance. Setback
usually ranges from
1
⁄
8
" to
1
⁄
4
".
2. Mark the hinge cup center line, as illustrated
in
Figure 40. In this example, the center line
is 17.5mm from the setback, which itself is
1
⁄
4
"
from the cabinet door edge.
(Top View)
Setback
Center
Line
1
/
4
"
17.5mm
Figure 40. Example of marking setback and
centerline.
3. Place the scrap board against the table and
fence.
4. Lower the downfeed handle, then use the
lateral adjustment knob to align the tip of the
cup bit to the centerline.
Summary of Contents for G0718
Page 52: ......
