Model G0718 (Mfd. Since 12/10)
-17-
5. Slide the fence extension rods into the table
fence, then tighten the cap screws to hold the
fence extension in place (see
Figure 13).
Note: If you decide not to install the fence
extension at this time, it can be set aside with
the extension rods and stored for later use.
7. Mount the boring head to the spindle, making
sure the slot in the boring head shaft (see
Figure 15) is aligned with the tang in the
spindle.
Figure 15. Installing boring head on spindle.
Slot
Boring
Head
Spindle
8. Secure the boring head with (4) M6-1 x 65
cap screws at the inside holes shown in
Figure 16.
Figure 16. Securing boring head to machine.
M6-1 x 65 Cap Screws
(3 of 4 Shown)
Figure 13. Fence extension installed.
Figure 14. Dust port installed.
6. Install the dust port.
Summary of Contents for G0718
Page 52: ......
