-24-
Model G0718 (Mfd. Since 12/10)
Many Euro-style cabinet hinge styles are available,
but not all can be used with this machine. Your
hinge must fit the three-hole pattern drilled by one
of three boring heads designed for this machine.
Also, the hinge mounting holes should fit one of
the three bit sizes.
The pilot bits drill the hinge mounting holes, as
shown in
Figure 30.
Boring Head Setup
Figure 29. Chucks with boring bits installed
(guard removed for clarity).
Chuck
Set
Screws
Cup Bit
Pilot
Bits
The Model G0718 accepts two pilot bits and a cup
bit, as shown in
Figure 29.
A
B
Mounting Hole
45mm
48mm
52mm
42mm
9.5mm
6mm
5.5mm
11mm
Mounting Hole
Hinge Cup Hole
Figure 28. Dimensions required for matching
hinge to boring head.
Measure (A) the center-to-center distance
between hinge mounting holes, and (B) the
distance between the center line of the hinge cup
and a mounting hole (see
Figure 28). Refer to
Accessories, Page 32 for boring head models.
Selecting Boring Head & Bits
(Top View)
Cup Hole
Hinge
Mounting
Holes
Figure 30. Holes drilled in workpiece by boring
bits.
Replace the boring head if you need to use one
with a different drilling pattern.
To replace the boring head:
1. DISCONNECT BORING MACHINE FROM
POWER!
2. Remove the clear guard and the boring bits.
3. Pivot the swing arm up.
Replacing Boring Head
The diameter of the pilot bits, either 3, 8, or 10
mm, determines the diameter of the hinge mount-
ing hole. The 35mm cup bit drills the center cup
hole.
Because mounting hole sizes vary depending
upon the hinge used, boring bits must be pur-
chased separately. Refer to
Accessories on
Page 32 for further details.
Tools Needed
Qty
Small Flat Head Screwdriver ............................. 1
Hex Wrench 2.5mm ........................................... 1
Hex Wrench 5mm .............................................. 1
Summary of Contents for G0718
Page 52: ......
