Model G0700 (Mfd. Since 5/14)
-39-
The miter fence is graduated in 5˚ increments
and can be angled anywhere between 45°L and
45°R.
The angle of the miter fence is adjusted by loos-
ening the lock handle (
Figure 56), rotating the
fence to the angle shown on the scale, then tight-
ening the lock handle to secure it in place.
Miter Cutting
3. Position the flip stop according to the length
of the workpiece you want to cut off to the left
of the blade.
4. Load the workpiece onto the table saw
(similar to
Figure 58) and perform the cutting
operation in the same manner as a crosscut.
Figure 58. Fence set-up for 45°L cuts.
Figure 57. Fence set-up for 45˚R cuts.
To perform a miter cut:
1. Install the miter fence on the sliding table.
2. Position the miter fence at the desired angle
for the cut and lock it in place.
Figures 57–58
show the miter fence set up for 45° cuts in
both directions.
Figure 56. Miter fence.
Lock Handle
Scale
Summary of Contents for G0700
Page 17: ...Model G0700 Mfd Since 5 14 15 Hardware Recognition Chart...
Page 85: ......
