Grizzly G0695, Owner'S Manual

Page: 26 / 56

-24-
Model G0695 (Mfd. Since 01/17)
Hold the motor housing when tilting. Do
not hold the drawbar cap. If you do, the cap
can come off and the headstock can swing
down uncontrollably, causing severe per-
sonal injury or machine damage.
Headstock Tilting
The head tilts from 45º right to 45º left (see
Figure 22). However, the headstock can be tilted
past 45ºR or 45º. If this is done, you will not be
able to use the angle scale, and the headstock
lock bolts may bind.
NOTICE
This mill is designed to operate with a right-
left headstock tilt of 45º. To prevent head-
stock binding and insufficient support, do
not tilt the headstock to a full 90º. Binding
occurs when one of the hex bolts on the
side of the headstock (Figures 23–24) binds
in the T-slot.
Figure 22. Head tilted 45° to the left.
Tools Needed Qty
Wrench 19mm ................................................... 1
To tilt the head:
1. DISCONNECT MILL FROM POWER!
Tilt
2. Loosen the two locking hex nuts on both
sides of the turret (see Figures 23–24).
Figure 21. Y-axis limit stops and block.
Limit Block
Y-Axis Limit Stops
Always keep the table locked in place unless
controlled movement is required for your
operation. Unexpected table movement dur-
ing operations could cause the cutter to
bind with the workpiece resulting in damage
to the cutter and workpiece, and possible
personal injury.