Grizzly G0679, Owner'S Manual

Page: 22 / 56

-20-
g0679 stroke/Edge sander
Machine Leveling
21
. attach the auxilliary workstop rods by thread-
ing the workstop rods into the machine base,
then sliding the workstops over the rods and
tightening the knobs. (
figure 31 ).
figure 31.
Auxiliary workstops.
Workstop
rods
Workstop
Knobs
22
. thread the belt tilt lever into the platen
assembly, as shown in figure 32 .
figure 32.
Belt tilt lever.
Belt tilt
lever
once assembly is complete, move your machine
into position, then level it. use a level to check
from side-to-side and front-to-back.
to adjust for level from side-to-side, use shims
under the rear feet of the machine.
to level from front-to-back, use the leveling feet.
thread each foot in or out as necessary, then
tighten the jam nut to secure it in position (
figure
33
).
figure 33.
Machine leveling.
rear Foot
leveling Foot