Grizzly G0654, Owner'S Manual

Page: 25 / 56

Model G0654 (Mfg. Since 9/07)
-23-
For your convenience, the adjustments listed
below have been performed at the factory and no
further setup is required to operate your machine.
however, because of the many variables involved
with shipping, we recommend that you at least
verify the following adjustments to ensure the best
possible results from your new machine.
step-by-step instructions for these adjustments
can be found in
SEcTION 7: SERvIcE.
factory adjustments that should be verified:
1. Knife settings (see page 38).
2. depth scale Calibration (see page 40).
3. Fence stop accuracy (see page 41).
Recommended
Adjustments
Tighten v-Belt
the final step in the setup process must be done
after approximately 16 hours of operation. during
this first 16 hours, the v-belt will stretch and seat
into the pulley grooves. after this 16 hours, you
must tension the v-belt to avoid slippage and burn
out. refer to
page 35 when you are ready to per-
form this important adjustment.
Note: Pulleys and belts can get hot. This is a nor-
mal condition. Allow them to cool before making
adjustments.
A small amount of black belt dust at the bottom
of the belt housing is normal during the life of the
machine and does not indicate a problem with the
machine or V-belt.
Test Run
once the assembly is complete, test run your
machine to make sure it runs properly.
if, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review the
Troubleshooting on page 36.
if you still cannot remedy a problem, contact our
tech support at (570) 546-9663 for assistance.
To test run the machine:
1. make sure you have read the safety instruc-
tions at the beginning of the manual and that
the machine is setup properly.
2. make sure all tools and objects used during
set up are cleared away from the machine.
3. Connect the machine to the power source.
4. turn the machine ON.
5. listen for abnormal noises or actions and
watch for vibration. the machine should run
smoothly.
— strange or unusual noises must be inves-
tigated and corrected before operating the
machine further. always disconnect the
machine from power when investigating or
correcting potential problems.
6. turn the machine OFF.
—if your outfeed table is correctly set, no
adjustments are necessary.
—if the knife lifts the straightedge off the
table or the table is below the straightedge,
loosen the outfeed table lock, and adjust
the outfeed table height with the hand
wheel until the straightedge just touches a
knife at its highest point of rotation.
5. lock the outfeed table, re-install the
cutterhead guard, and close the rear access
panel.