-50-
Model G0634X (Mfd. Since 11/20)
The depth scale on the infeed table can be cali-
brated or "zeroed" if it is not correct.
Items Needed
Qty
Straightedge ...................................................... 1
Phillips Screwdriver ........................................... 1
To calibrate depth scale:
1.
DISCONNECT MACHINE FROM POWER!
2.
Set outfeed table height as described in
Setting Outfeed Table Height
on Page 44.
3.
Use straightedge to help adjust infeed table
exactly even with outfeed table, as shown in
Figure 72
.
4.
Using screwdriver, adjust scale pointer to
zero (see Figure 73).
Figure 72.
Infeed table even with outfeed table.
Straightedge
Infeed
Outfeed
Figure 73.
Depth scale adjusted to “0” position.
Depth Scale
Pointer
Depth
Scale
Calibrating Depth
Scale
Setting Fence Stops
The fence stops simplify the task of adjusting the
fence to 45˚ and 90˚.
Items Needed
Qty
45° Square......................................................... 1
90° Square ........................................................ 1
Sliding Bevel ...................................................... 1
Wrench 10mm ................................................... 1
Wrench 12mm ................................................... 1
Hex Wrench 3mm .............................................. 1
Hex Wrench 4mm .............................................. 1
2.
Place 90° square against table and fence,
and adjust stop screw so fence is set exactly
at 90°.
3.
Tighten lock nut.
Figure 74.
Adjusting fence to 90°.
90˚Stop Screw
Lock Nut
Setting 90° Fence Stop
1.
Loosen lock nut on 90° fence stop screw
shown in Figure 74, and loosen fence tilt
knob.
1.
Loosen fence tilt knob and position fence
against 45° stop bolt.
Setting 45° Fence Stop
Summary of Contents for G0634X
Page 68: ......