Model G0634X (Mfd. Since 11/20)
-43-
3.
Remove belt tension knob (see Figure 49 on
Page 42
).
4.
Loosen (4) motor mount adjustment nuts and
raise motor (see Figure 52) to completely
remove V-belt tension. It may help to use a
2x4 as lever to lift motor.
5.
Remove both belts and replace them with
new matched set.
6.
Lower motor, retighten motor mount adjust-
ment nuts.
7.
Rotate pulleys by hand to ensure V-belts are
properly seated in pulleys.
8.
Reinstall cutterhead pulley cover and belt
tension knob from Steps 2–3.
9.
Properly tension V-belts according to
Tensioning V-Belts
on Page 42.
10.
Reinstall motor access panel from Step 2 on.
Note
: After first 16 hours of belt life, re-ten-
sion belts, as they will stretch and seat during
this time.
Figure 52
. Removing V-belt tension for belt
removal/replacement.
Motor Mount
Adjustment Nuts
(3 of 4)
2x4 Lever
Adjusting Pulley
Alignment
Items Needed:
Qty
Wrench 10mm, 12mm ..................................1 Ea
Straightedge ...................................................... 1
Hex Wrench 3mm .............................................. 1
C-Clamps .......................................................... 2
Proper motor and cutterhead pulley alignment
prevents premature belt wear. The pulleys are
properly aligned when they are parallel and in the
same plane as each other.
To align pulleys:
1.
DISCONNECT MACHINE FROM POWER!
2.
Remove fence, cutterhead pulley cover, and
motor access panel (see Figure 53).
Cutterhead
Pulley Cover
Motor Access
Panel
Fence
Figure 53
. Location of fence, cutterhead pulley
cover, and motor access panel.
Summary of Contents for G0634X
Page 68: ......
