-32-
Model G0634X (Mfd. Since 11/20)
Jointer/Planer
Conversion
3.
Remove dust hose from jointer dust port.
4.
Rotate infeed table lock lever (see Figure 33)
clockwise, pull it out, and pivot table upward.
Figure 33
. Location of infeed table lock lever.
5.
Raise outfeed table in same manner as you
did with infeed table.
6.
Swing planer dust port clockwise over
cutterhead and connect dust collection hose,
as shown in Figure 35.
7.
Move jointer/planer selection lever to up posi-
tion (see Figure 35).
Table Lock
Lever
Figure 34
. Infeed table pivoted up.
The Model G0634X is ready for jointer operations
after it is first setup. To use the machine as a plan-
er, you must convert it from a jointer to a planer.
Figure 32
. Fence removal components.
Fence Rail
Bracket
Fence Lock
Lever
Protective
Flap
Note:
Table will lock into place when raised
to its highest position, as shown in
Figure 34.
Figure 35
. Machine converted to planer.
Planer Dust
Port
Selection
Lever
In Up
Position
Converting for Planer Operations
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen fence lock lever, slide fence toward
front of machine, carefully slide protective
flap through bracket, and lift fence off of fence
rail (see Figure 32).
Summary of Contents for G0634X
Page 68: ......
