Grizzly G0554, Owner'S Manual

Page: 31 / 94

g0554 gear-head Floor lathe
-27-
Drilling with the
Tailstock
Figure 31. setting up tailstock for drilling.
Figure 32. tapered shank drill fitting into quill
taper.
To install the tapered drill chuck:
1. With the tailstock locked, push down to
unlock the quill lock handle.
2. turn the quill feed handle clockwise to extend
the quill about one inch.
3. insert a tapered drill arbor (Figure 31), or the
tapered drill shank ( Figure 32), into the quill
until the taper is firmly seated. the matching
tapers hold the arbor.
4. turn the quill feed handle clockwise to feed
the drill bit into the rotating workpiece.
5. to remove the chuck taper, turn the quill feed
handle counterclockwise until the chuck is
pushed out from the tailstock taper.
cutting Shallow
Tapers with the
Tailstock
the tailstock can be offset to cut a shallow taper
on a part.
To set up the tailstock to cut tapers:
1. lock the tailstock in position.
2. loosen the set screw located just above the
adjustment screw (see Figure 33).
Figure 33. tailstock off-set adjustments.
Adjustment screw
set screw