Grizzly G0526A40, Owner'S Manual

Page: 36 / 60

-34-
Model G0526A40 (Mfd. Since 12/22)
Figure 43. Location to lubricate table ways.
Table Ways
Oil Type ................SB1365 or ISO 68 Equivalent
Oil Amount ...........................................1–2 Drops
Lubrication Frequency ....................... As Needed
Lower infeed and outfeed tables to access ways.
Place a couple of drops of oil at top of each way,
at both front and rear of machine, and move tables
up and down to distribute oil (see
Figure 43).
Wipe off excess oil.
Since all bearings are sealed and permanently
lubricated, simply leave them alone until they
need to be replaced. DO NOT lubricate them.
It is essential to clean components before lubri-
cating them because dust and chips build up on
lubricated components and make them hard to
move. Simply adding more grease to them will not
yield smooth moving components.
Clean the components below with mineral spirits
or other oil/grease solvent cleaner and shop rags.
Figure 41. Recommended product for machine
lubrication.
SB1365—South Bend Way Oil-ISO 68
Lubrication
Infeed/Outfeed Table Leadscrews
Oil Type ................SB1365 or ISO 68 Equivalent
Oil Amount ............................................Thin Coat
Frequency .......................................... As Needed
Lubricate the outfeed table leadscrew with light
machine oil as needed (see
Figure 42). Wipe off
excess oil and sawdust with a cloth.
Figure 44. Fence lubrication locations.
Fence
Oil Type ................SB1365 or ISO 68 Equivalent
Oil Amount ...........................................1–2 Drops
Lubrication Frequency ....................... As Needed
Place one or two drops of light machine oil on
fence pivot points (see
Figure 44) as needed.
Figure 42. Leadscrew lubrication location.