Grizzly G0526A40, Owner'S Manual

Page: 21 / 60

Model G0526A40 (Mfd. Since 12/22)
-19-
14. Rotate cutterhead guard counterclockwise
and secure temporarily with a piece of scrap
wood (see
Figure 19).
12. Remove
1
⁄
4
"-20 x
1
⁄
2
" Phillips head screw and
5
⁄
8
" flat washer from end of cutterhead guard
shaft, loosen set screw in rabbeting table,
then slide shaft down through cutterhead
guard mounting hole (see
Figure 17).
— If
guard does fully seat in hole, proceed to
Step 13.
— If guard does not fully seat in hole, rotate
guard until it is fully seated, then proceed
to
Step 13.
Figure 19. Cutterhead guard secured in place.
13. Align corner of cutterhead guard with edge
of carriage, then secure set screw,
1
⁄
4
"-20 x
1
⁄
2
" Phillips head screw, and
5
⁄
8
" flat washer
removed in
Step 12 (see Figure 18).
Cutterhead Guard
Mounting Hole
Infeed Table
Cutterhead Guard
Assembly
Figure 17. Installing cutterhead guard.
Carriage
Alignment Area
Cutterhead
Guard
Figure 18. Cutterhead guard aligned with
carriage.
15. Place carriage support key and fence onto
fence carriage base, making sure fence fits
over key (see
Figure 20), then insert fence
lock handle and secure with
1
⁄
2
" flat washer
and locking jam nut.
Figure 20. Fence assembly installed onto
carriage base and secured.
Fence
Carriage
Base
Top View
Bottom View
Carriage
Support
Key
Flat Washer
& Locking
Jam Nut
Fence
Lock
Handle
Scrap
Wood