G0510 3⁄4 HP Shaper
-25-
Schedule
Regularly blow out hard to reach areas with com-
pressed air and keep the spindle clear of wood
dust and chips. Always wear a dust mask when
using compressed air this way.
For every
1 hour of use, clean and wipe down
with Boeshield™ T-9 or SLIPIT
®
:
•
Table and miter gauge slide
•
Fence faces
For every
5 hours of use, clean and oil:
•
Offset adjustment mechanisms on fence
Once a year, replace the V-belt.
V-Belt Tension
You should be able to deflect the belt
1
⁄
4
" with
moderate finger pressure. This may seem tight
compared to most other V-Belts, but since the belt
is small and runs fast, this much tension is nec-
essary. The V-Belt will slip if too loose and squeal
or cause vibration if too tight. Adjust the tension if
necessary.
To adjust V-Belt tension:
1.
Make sure the pulleys are properly aligned.
2.
Loosen the two motor mount plate bolts and
slide the motor left or right to modify the belt
tension. Keep the pulleys aligned.
3.
Tighten the motor mount plate bolts, test the
tension, and check pulleys.
4.
Repeat steps 2-3 until tension is correct, and
pulleys are aligned.
Summary of Contents for G0510
Page 39: ......
