G0510 3⁄4 HP Shaper
-16-
Cutter Installation
Your shaper operates at 8900 RPM. Always use
1
/
2
” shaper cutters and never attempt to use router
bits!
To install a shaper cutter:
1.
Disconnect the shaper from the power
source!
2.
Place an appropriate spacer or collar (if
needed) at the base of the spindle for sup-
port.
3.
Place the cutter on the spindle. Make sure
the rotation is correct for your application.
4.
Use spacers or collars as needed for your
particular application.
5.
Place the spindle washer on top of the spac-
ers/cutter, and thread on the locknut.
6.
Tighten the nuts while holding the spindle
stationary. Use a wrench on the notches at
the top of the spindle for leverage.
See
Figure 10.
Spindle Height
To adjust the cutter height:
1.
Loosen the spindle lock shown in
Figure 11.
2.
Move the spindle up or down with the eleva-
tion adjustment handle, shown in
Figure 12,
until the desired position is obtained.
3.
Lock the spindle into position.
Figure 12. Spindle elevation adjustment handle.
Figure 11. Spindle height lock knob.
Figure 10. Tightening spindle lock nut.
Summary of Contents for G0510
Page 39: ......
