G0510 3⁄4 HP Shaper
-19-
Partial Face Removal
Perimeter Cutting
Figure 19. Partial feed fence adjustment.
If the face of the workpiece will only be par-
tially removed, observe the following steps:
1.
Adjust the infeed fence to approximately the
desired depth of cut, and lock the infeed
fence in place.
2.
Use a straightedge to adjust the outfeed
fence to the same plane as the infeed fence,
and lock the outfeed fence in place.
3.
Set the right and left wood faces to barely
clear the cutter. This allows the maximum
support possible for the workpiece while
passing the cutter. Remember to tighten
down the wood facing before starting the
shaper.
4.
Run a test piece through the shaper.
See
Figure 19.
Figure 20. Cut sides with end grain first.
If an edge around the perimeter of a workpiece
is to be cut, observe these steps:
1.
Cut the sides with end grain first.
2.
Cut the sides with the grain last, or in the
sequence shown in
Figure 20.
Summary of Contents for G0510
Page 39: ......
