-50-
Model G0449/G0450 (Mfd. Since 8/13)
Figure 71. Drum sander disassembled
to
Step 11.
6. Remove the front and rear upper frame
angles (4 cap screws, 4 lock washers, and 4
flat washers on each one).
7. Remove the table height lock knob.
8. Remove the feed motor cover (4 button head
screws and setscrew on knob).
9. Remove the front conveyor guard (4 button
head screws) and the cord clamp, and set
the front conveyor guard off to the side of the
machine.
10. Remove the rear conveyor end guards (4 but-
ton head screws). The drum sander should
now look similar to
Figure 71.
Figure 72. Chain removed from table by
removing the master link.
Figure 73. Conveyor belt loosened at the rear
adjustment.
14. Loosen the conveyor belt from the rear
adjustments, as shown in
Figure 73.
11. Raise the table up to the 1" mark on the
scale.
12. Mark the position of the chain and sprock-
ets.
13. Loosen the chain idler adjustment sprocket,
carefully pull the chain off of all the sprockets,
and remove it from the cabinet by undoing
the chain master link, as shown in
Figure 72.
Summary of Contents for G0449
Page 80: ......
