Grizzly EXTREME G0513X2B, Manual

Page: 51 / 104

G0513X/G0514X/G0514X3 Extreme Series Bandsaw
-21-
Figure 14. Quick release tension lever.
Tighten
Loosen
2.
Adjust the upper and lower blade guides
away from the blade. Refer to Adjusting
Blade Guide Bearings
on
Page 29
for more
details.
3. Open the upper and lower wheel covers, and
slide the blade off of both wheels.
All saw blades are dan-
gerous and may cause
personal injury or death.
Wear leather gloves when
handling.
Table
Figure 15. Mounting the table.
Personal injury may occur
if the table is lifted without
assistance. Get help when
installing the table.
The table is heavy and requires two people to lift
it onto the trunnions. The saw blade should also
be removed to make table installation easier.
Components and Hardware Needed: Qty
Table .................................................................. 1
Hex Bolts M8-1.25 x 16 ..................................... 4
Lock Washers 8mm ........................................... 4
Flat Washers 8mm ............................................ 4
Table Pin ........................................................... 1
Table Insert ....................................................... 1
To install the table:
1.
Loosen blade tension by rotating the quick
release tension lever clockwise as shown in
Figure 14
.
4.
With the help of another person, lift the table
onto the trunnions.
5. Secure the table to the trunnions as shown
in
Figure 15
with the supplied hex bolts and
washers.
6.
With the blade teeth pointing downward, slide
the blade through the table slot.
7. Slide the blade through the upper and lower
blade guides, and mount it over the upper
and lower wheels.
8. Tighten the quick release tension lever, then
install the table insert and table pin.
9.
Keep the upper and lower blade guides
adjusted away from the blade until the blade
tracking and tension have been adjusted.
Trunnions